how to mount an am/fm antenna in an rv - small electrical appliances

One way to enjoy music in an RV is to install a car stereo.
It's good to do this: Car Stereo at 12-
DC voltage (DC)
Like most RV appliances, move 12-
Volt Electronics ensures reliable operation.
If you install the car audio into an RV without an antenna, such as a fifth wheel or a travel trailer, you will need to install an AM/FM antenna to make sure you can listen to the radio.
Difficulties: where is the antenna installed?
While it depends on the architecture of your particular RV, consider factors such as the location of the radio where you will be connecting it.
Choose a position that allows you to extend the antenna high enough without any obstacles.
Select a "universal" antenna that adapts to different mounting locations.
Drill a hole large enough in your RV to hold the cable for the antenna. A 1/4-
The inch opening is usually enough.
Push the hard wire into the opening so you can find the opening from inside the car.
Push the end of the antenna cable into the RV and route the cable to the location of the radio.
Place the base of the antenna bracket on the side of the RV as a template for mounting screws.
Drill holes on the RV where the antenna mounting plate screw holes are located. Use a 1/16-
An inch bit of pilot hole.
Twist the mounting plate of the antenna to the side of the RV, and then use the hardware that comes with the antenna to install the antenna on the mounting plate.
Nicole Liandi, an article written by Virginia-based Nicole Liandi, has been a freelance writer since 2005.
Her articles appear in various print and online publications.
Lian Di has traveled in Europe and East Asia and incorporated her experience into her article.
She holds a bachelor's degree in history from the University of West Virginia.