3d printed air purifier -- get rid of abs smell and voc's - good air purifier

To put it up: some people who are smarter than me commented that this is not getting rid of UFP (
Fine particles)
There is a P100 filter in this respirator cartridge, but some super particles will still pass through.
It can still remove odor and VOC, the carcinogenic substance formaldehyde.
In addition to making sure your room is sealed and/or venting it outside (best way).
I just want you to know :)Hey guys! Hows it going? ! ? ! ? ! ? !
So I have been addicted to 3D printing for 3 years and I have given up. . . ahem. .
I put almost every penny of my money into this hobby.
Key words: investment (
Means I have a clear conscience when I see how much money is in ol bank account)
Now I like to print with ABS.
In fact, I have done a lot of printing with this smelly twisted garbage and I have even found some way to partially "cancel"
Those stupid things.
It's only $50 now (
Not including enclosure)
Solve another huge drawback of ABS (
The part where it stinks and stinks is poisonous).
It's not easy but here!
I call it "Air Elf 2 ". 0 5,000".
JK butt seriously said, no, this is just the air purifier inside the printer housing.
It is very easy to print and assemble.
It uses easy to find and replace the respirator cartridge!
This particular one I am using is "3 m formaldehyde organic steam filter cartridge/filter 60925, P100 breath protection" which is the best type of this application as far as I know.
Links to files and parts :(1x)
120mm radial Blower (1x)
12 v wall adapter (1x)
2 packs of filterscheap pla I like to use (1x)
Part of the file is in Thingiverse.
ComNote: Some of these links are affiliate links (
Clicking on the link or better purchasing the item will help support the development of future projects.
It doesn't cost you anything, though! )
As an Amazon employee, I earn money from qualified purchases.
1: print the adapter out 2: put a circle of hot glue around the edge of the fan to seal.
Make sure to press the adapter while it's still hot.
3: optional but recommended--
Fan4's Bolt adapter: screw it on the respirator box and you can go!
Hope you find this useful!
Can you subscribe to me for a YouTube if not very troublesome?
Disclaimer: please always contact your manufacturer and keep in mind that this air purifier has not been tested and I cannot guarantee that it works.